18650 V8 akkumulátorvédő - 18650 V3 V8-os akkumulátor V8 mobilhálózati 3V 5V-os USB-kábel az ESP3266 ESP3266-hoz

A cím elején szereplő szín/minta/méret/típus kerül kiszállításra!
18650 Battery Shield V3 V8 Mobile Power Bank 3V 5V USB Cable for ESP32 ESP8266
18650 Battery Shield V3
Features:
Battery protection(Over charge or Over discharge)
Micro USB port Input
Type-A USB Output
0.5A current charging
1 switch control USB output
5~8V Input Voltage
3V & 1A Output
5V & 2A Output
LED indicate(Green means full,Red means charging)
3V output port x3
5V output port x3
Be careful of " " and "-", You should follow the direction of " ""-" on the PCB.
Size: 9.8x2.9cm/3.86x1.14inchOptional:
Battery Shield Cable
Battery Shield1.Please allow 1-5mm error due to manual measurement. pls make sure you do not mind before you bid.
2.Due to the difference between different monitors, the picture may not reflect the actual color of the item. Thank you!
3. If you put wrong direction, charging chip will be destroyed.
4.This product does not include 18650 batteryPackage included:
1 x Battery Shield Module with Cable or not (battery not include) 18650 Battery Shield V8Description: This module is a portable mobile power supply that supports 3V / 1A and 5V / 2.2A two voltage outputs!
5V voltage output rated current is 2.2A, maximum support 3A current (not recommended for overload, easy to damage the module, speed up the service life), the output of current depends on the quality of the 18650 battery!
MICRO USB charging current 600mA-800mA,
Supports up to two 18650 batteries. It is recommended to use two 18650 batteries, which can be longer!
Special attention: the installation of the battery must be determined positive and negative, the board has been clearly marked positive and negative! Installation errors will burn out the module!
Package Included: 1*Mobile Power Bank 18650 Battery Shield V8 5V Micro USB for Arduino ESP32 ESP8266
312533926410/2 - ali110 (280)